| Author | Topic |
|---|
Location:
townsville NQLD
Registered:
February 2004
|
|
Re: WTD: 18RG
|
Fri, 22 April 2005 11:58
 
|
 |
i **may** (speculation for now) be going to sell ny 18RG (U).
totally complete
casting: 88253 (biggest ports and valves- 8.7:1 )
-fully rebuilt
-new rings (honed)
-all new bearings - very good condtion - very little wear - 2 thou clearances for all of them
-bore to piston clearance was ~4 thou (standard) - this motor has little wear from origional
- new timing chains
-inlet valves reground - all valves lapped
-all new gaskets
- new valve stem seals
- all valve clearances set perfect
- heat shaved (4 thou) and dipped
- old 18RG carbys (no pollution crap)
- ramflow air filters (brand new)
- HUGE extractors - way thicker than pacemakers
probly more but cant think of rite now
the engine has only had about 5 ~ 8 hours of running sice rebuild
cost me $1000 to rebuild (genuine stuff costs a bit) .....have all recipts to show ~$1000 parts/work 
heaps of time spent gettin this motor done PROPERLY
asking: $1200
goes pretty good 
brett
|
|
|
