Location: Brisbane, Queensland
Registered: January 2004
Re: Re-Use piston rings?
Tue, 26 April 2005 23:26
Allan wrote on Tue, 26 April 2005 22:34
errrr the oil filter should of got it, worst case your oil pump should be shaged, that could of caused low oil pressure and your barings to suffer, have you plasti gauged the crank?
visually there is no major damage to the crank/rods and should linish out. I don't have the engine at the moment the rebuilder has it and is tearing it down as we speak.
Well i had 2 options, either clean up the bearings/crank/rods and stick it all back togther, or pull the whole lot down. I went with the latter. Cause it might save me rebuilding it a 3rd time int he long run.