Toymods Car Club Inc: Tech & Conversions => 2tg piston hits valve after hibread makeover

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » 2tg piston hits valve after hibread makeover Show: Today's Posts :: Show Polls Email to friend

Author

Topic

wagonist
Forums Junkie

Toymods Club Treasurer

Location:
Sydney
Registered:
May 2002

Re: 2tg piston hits valve after hibread makeover

Sun, 01 May 2005 09:19

goonman86 wrote on Sat, 30 April 2005 22:19

now i rebilt my 2tgue with the crank from a 3tgte and new 1mm over sized pistons and got them fly cut. got the head rebilt now i put it all together and i think number 3 piston is hitting the ex vavle. now what could of done this if they where all fly cut the same depth? im yet to pull the head off and have a look but i think its only just tapping the top of the piston. it still runs well but just rattly. still got stock cams so thats not a problem. should i get out the shot gun and take out the nee caps off the guy that did the pistons? or is it not his falt. any info would be great

Gonnman86, also consider yourself on probation for the same reason as LAA-80E.
Toymods does not condone violence against anyone.
If a moderator has any reason to warn you again you will be banned from the forums.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Jul 21 01:22:35 UTC 2025

Total time taken to generate the page: 0.0039739608764648 seconds

.:: Contact :: Home ::.