Toymods Car Club Inc: Tech & Conversions => Sprinter master cylinder upgrade

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Sprinter master cylinder upgrade Show: Today's Posts :: Show Polls Email to friend

Author

Topic

DAMO
Regular

Location:
MELBOURNE
Registered:
May 2002

Re: Sprinter master cylinder upgrade	Wed, 18 December 2002 11:44

EVOSTi, this is the setup that we are putting on a friends Sprinter this weekend and this is the master cylinder we are using. The brake pipe that goes to the back brakes stays the same and the front needs a new pipe to be made. Very easy. Check clearances on actuator and your done. I checked out one off a fj40, which I don't know if there are different types but it had four bolt holes, not two. Another cylinder I think will fit which is 7/8 is one off a corona (part no. JB1335(I think)). [Report message to a moderator]

Current Time: Fri Jul 18 11:38:50 UTC 2025

Total time taken to generate the page: 0.0040068626403809 seconds

.:: Contact :: Home ::.