Toymods Car Club Inc: Tech & Conversions => 20V silvertop oxygen sensors

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 20V silvertop oxygen sensors Show: Today's Posts :: Show Polls Email to friend

Author

Topic

oldcorollas
Forums Junkie

Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003

Re: 20V silvertop oxygen sensors	Mon, 09 May 2005 12:43

if you wanted to stay single wire, then any of the single wires will fit. the threads are all the same (well nearly all are M18x1.5) and you can get/make a flange if the original one was. i actually had some of these.. OS506, and also OS508's http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?Vi ewItem&rd=1&item=7972839714&category=3 3557&sspagename=WD2V US$20 + maybe US$10-20 shipping?? i prefer heated sensors... you could use something like this 3 wire http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&a mp;category=33557&item=7971937140&rd=1 as it still has single wire to ECU, and the other two wires are for the heater (ie one to earth, and one to an ign switched source) i prefer 4 wires, and i also prefer Bosch or NTK sensors, but have not had any bad reports about the borg warner or the NAPA/Echlin ones either... if you can land a bosch 4 wire here for $60 or less, i would do that. Cya, Stewart http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?Vi ewItem&rd=1&item=7972622120&category=4 6097 4 wire 99c!!!!!!!!!!!!!! if i was not leaving i'd buy it [Report message to a moderator]

Current Time: Mon Jul 28 00:24:52 UTC 2025

Total time taken to generate the page: 0.006695032119751 seconds

.:: Contact :: Home ::.