| Author | Topic |
|---|
Location:
Adelaide
Registered:
May 2003
|
|
Re: Engine Electrics (Amperage Draw)
|
Mon, 16 May 2005 13:42
|
 |
Im trying to figure it out so i can use a quick connect for the entire engine loom, in order to simplify the Haltech wiring loom. The wire which the quick connect has should be around the 10A mark, but what normally flows down it is around 2A or so, so i know that thats the nominal max.
Im using Coil over Plug packs and as such there are 3 connectors on the coil/igniter. Power, ground, signal. The power and ground would be a 30A rail shared between 4 coils/igniter combos. While im hoping that the signal can be passed along the quick connect.
Currently its looking like i can use the quick connect for everything bar the major power supplies. I.e. coil power and ground. Which i will be able to use a seperate 2pin nylon 30A connector for as detailed above.
|
|
|
