| Author | Topic |
|---|
Location:
perth
Registered:
October 2004
|
|
Re: tough 3tg
|
Wed, 25 May 2005 09:42
 
|
 |
cheers for that johnny. i want the power range to be a lil lower seeing as how this will be driven on streets too. what sort of power is your package making and at what sort of revs?
1/4mile times? just curious
is it worth spending the money on forgies? how much of a hard time can standard 3tc pistons take?
also with boring the block should i go all out and have bored to 88.5 or a bit less to retain strength?
also a query regarding oil pumps. should i use a 3tgte oil pump? or is the 2tgeu one up to the task?
ive done some research on this but there aint much on them here.
apparently the 3tgte oil pump runs off a small shaft which runs off the dummy cam. then there is a plate over the dizzy hole cause the dizzy comes out from the head on 3tgte.
so my question is can you not use that small shaft but use a 2tgeu elec dizzy to drive the pump instead without any hassles?
would a 3tgte item supply to much pressure for my engine?
cheers for your help
craig
|
|
|
