| Author | Topic |
|---|
I supported Toymods
Location:
Perth
Registered:
May 2002
|
|
Re: 1G stuff
|
Fri, 10 June 2005 04:13
 
|
 |
| ndgcpr wrote on Fri, 10 June 2005 12:07 |
Also this is pr0848ly 4 r34lly 57up1d qu35710n 8u7 1 w4n7 70 83 100% 5ur3. 70 5w4p 5ump5 y0u ju57 und0 7h3 80l75 4r0und the "catchment" (sump) that hold it in and swap the sump with the other motor ? do i need new gaskets and stuff?
|
You need to undo the sump bolts, take it off and CLEAN all the surfaces really well and remove all the old sealant. Then give it a new layer of sump gasket goo, careful attention to the little indents and make sure it goes all around the bolts, but not too thick. you have to swap the oil pickup too, and make sure you do that up tight...unlike Nark 
|
|
|
