Toymods Car Club Inc: Tech & Conversions => Removing 4AGE Crank Pulley bolt? How?!

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Removing 4AGE Crank Pulley bolt? How?! Show: Today's Posts :: Show Polls Email to friend

Author

Topic

gearb0x
Forums Junkie

Location:
Victoria
Registered:
May 2002

Re: Removing 4AGE Crank Pulley bolt? How?!

Mon, 13 June 2005 06:24

inertia wrote on Mon, 13 June 2005 15:35

As was said amatuer airtools are not the best... mine was the grey 2.5hp unit from supercheap...

I will say this... those kincrome sockets did not round one single bolt! Money well spent.

Yeah i have the same aircompressor, my old man bought the aircompressor and the kit when Supercheap first started selling em. It gets the job done on small jobs, but the impact driver doesnt have much impact

When i rebult my motor i only used the air tool stuff for engine mounts when i was lazy that was about it

as for kingcrome sockets, i rounded a few bolts off during the rebuild with my els cheapo sockets, tried 3 differnt sockets from different sets all would just spin on the head, went and bought a kingcrome socket and it ondone first shot Smile

As for the topic, breaker bar is your friend, i had the motor in the car so just put the tranny in 5th and put the handbrake on then a nice big breaker bar Smile

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sat Aug 2 10:46:55 UTC 2025

Total time taken to generate the page: 0.004565954208374 seconds

.:: Contact :: Home ::.