Toymods Car Club Inc: Tech & Conversions => MA61 cruise with manual

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » MA61 cruise with manual Show: Today's Posts :: Show Polls Email to friend

Author

Topic

bbaacchhyy
Forums Junkie

Location:
Adelaide
Registered:
September 2003

Re: MA61 cruise with manual

Sun, 26 June 2005 05:43

HKS_TRD wrote on Sat, 25 June 2005 23:46

I had retrofitted the cruise to my factory manual MA61 and got it to work. There were 2 things I had to do. Firstly I installed the cruise control stop switch on my clutch pedal which I sourced from the US as there was no factory 5sp MA 61 sold in Australia. The second problem I had and one which is probably your answer is that the brake light switch for cruise equipped cars is different to non cruise equpped cars. The swtich has a second set of contacts that kill the cruise control when you apply the brakes. I ended up just shorting the wires for this switch rather than buying the correct switch. Now your car originally had cruise but perhaps when you did the pedal swap for the manual conversion you carried over the old switch from the manual pedal set? I hit a brick wall tyring to get the cruise to work(everything else plugged in and the control on the dash lit up) untill I made this disccovery. Hope this helps

Cheers for that Danny. I'll see what I can find and sort out. I didn't change the brake switch when I put in the manual pedal. b(BTW, I still have the P/S reservoir if you still want it)

Beside the switches, did you have to run the wiring, or was it already there ?

CrUZida - My build plate is for an A43DL trans, but the ECT is clearly marked as being 7M-GTEU !!

[Updated on: Sun, 26 June 2005 05:48]

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Thu Nov 14 16:43:06 UTC 2024

Total time taken to generate the page: 0.0074539184570312 seconds

.:: Contact :: Home ::.