| Author | Topic |
|---|
Location:
Bundaberg, Qld.
Registered:
May 2002
|
|
Re: 4agte TVIS removal/disabling
|
Sun, 03 July 2005 11:51
 
|
 |
there are 2 small screws on each butterly plate, undo them and the butterfly plates fall off the rod/s. by memory (its was ages ago when i did it) there was a small circlip/s that held the rod into the 2 halves of the t-vis plate.
| Quote: |
Ever think of cutting out the centre part between the 2 holes in the one port on the tvis plate? Wouldn't this be better?
|
good point. i spose getting to it with a die grinder and taking out the center section where the butterfly plates where would have to benifit air flow i would think. not something i did, i didnt have a die grinder when i did it.
|
|
|
