| Author | Topic |
|---|
I supported Toymods
Location:
NE Melbourne
Registered:
May 2002
|
|
Re: EBC greenstuff V4
|
Sat, 08 June 2002 07:06
|
 |
Dylo...
The EBC greenstuff V4s from the Mitsubishi GTO cost me $217, but that is the trade price... RRP is $220+GST
with more kays on the pads they are beginning to bed in very nicely... EBC describe the pads as needing no warm up to work, but i do notice a nice increase in their performance after a few stops in normal traffic (but that suits me as the engine is cold too and no high speeds on a cold engine thakyou)...
The strut brace i made myself... the end plates are 6mm plate alloy that were laser cut to my dimentions... the bar is just a piece of ssteel rod drilled and threaded at each end, and there are rose joints to tie it all together (don't forget bolts/nuts)... to make one identical i don't know exactly the costs, cos again i payed trade for the parts... but as a guess i'll give you a ball park figure... alloy plates $60(including material) ssteel bar $20 rose joints up to $50each depending where you go and what size you choose (again i can't help with RRP cos i payed $40 for the pair, but i noticed that the RRP was around $45 each) and for the bolts i chose ssteel again and used two bolts with nuts between ball and alloy plate and a second locking nut on each rose joint where it screws into the ssteel bar (about $20 - ssteel bolts that size aren't cheap!!!) i'll try to get around to taking some close up pics and post them too on my site
good luck...
|
|
|
