| Author | Topic |
|---|
Location:
Brisbane
Registered:
June 2003
|
|
Re: brake calliper mount query
|
Sat, 23 July 2005 08:41
 
|
 |
i measured from the centre of the stub axle to the outside of the brake pad inside the calliper. then just worked out what offset i needed. Like say for a 300mm rotor, you would go 150 off centre. and if it was 32mm thick you would come up the required width. either do it with washers or cut up steel. taking the strut out to do it is a good idea  then you can do what i am and ship it off to the engineer and say "here make this" it will save you a LOT of money if you do the measuring etc.
|
|
|
