| Author | Topic |
|---|
Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003
|
|
Re: 5 speed ke 10 (Driveshaft problems)
|
Mon, 01 August 2005 13:51
|
 |
| swifty_ke10 wrote on Mon, 01 August 2005 19:51 |
Hello, ive just installed a 3k and 5 speed box into my 1968 toyota corolla. I encountered a problem when i realised that my stock ke10 tailshaft doesnt fit the 5 speed. So i ventured to the wreckers and bought a ke70 tailshaft (which is two piece; Unuseable). I bought this coz the spline off this tailshaft fits the 5 speed output shaft. i was going to take apart the uni and use it on my stock ke10 driveshaft, but alas, the uni is a different size and cant be swapped. All i need to know is what one piece tailshaft from later model corollas will fit the output shaft on my 5 speed, so i can get one and cut it down to fit my ke10. Or even better one that is the right size and will fit my 5 speed.
Any help is appreciated.
Plz email me at sid_vicious_stole_my_baby@hotmail.com
Luke Swift
|
i cbf emailing but.. 
if your KE10 has the small unis (some have large ones) just grab the front yoke of a KE30 with a jap dif.. ie it MUST have the small unis... it will swap straight over but new unis are a good idea.
KE55/KE70 with bog diff have the stoopid holden uni... sucks..
just use KE10 driveshaft (2" shorter than KE30), and a KE30 front yoke with the same size unis and all will be sweet.. i did this to my KE15 so i know it works...
Cya, Stewart
|
|
|
