Toymods Car Club Inc: Tech & Conversions => 1jz-gte Octane requirements.

Toymods Car Club
www.toymods.org.au

F.A.Q.

Toymods » Tech & Conversions » 1jz-gte Octane requirements. Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Soarer
Forums Junkie

Location:
Wollongong
Registered:
May 2002

Re: 1jz-gte Octane requirements.	Sun, 26 January 2003 00:59

I run my 1JZ on 98 octane (Optimax) and it runs fine. Just make sure your spark plugs are in good shape, cos they tend to misfire a bit under boost (in my experience). Yes, the knock sensor will retard the engine if lower octane fuel is used, but from memory, knock sensors are only active in closed loop ECU mode. If you are running WOT, I don't think they activate (although I could be wrong). Can anyone confirm ? [Report message to a moderator]

Send a private message to this user

[Message index]

Subject Poster Date

Read Message 1jz-gte Octane requirements. Ollygt Sat, 25 January 2003 11:47
Re: 1jz-gte Octane requirements. Remedy Sat, 25 January 2003 15:17
Re: 1jz-gte Octane requirements. Ollygt Sun, 26 January 2003 00:53
Re: 1jz-gte Octane requirements. Soarer Sun, 26 January 2003 00:59
Read Message Re: 1jz-gte Octane requirements. humble Sun, 26 January 2003 23:17
Re: 1jz-gte Octane requirements. Nark Tue, 28 January 2003 01:06
Re: 1jz-gte Octane requirements. Remedy Tue, 28 January 2003 01:24
Re: 1jz-gte Octane requirements. Tue, 28 January 2003 03:22
Read Message Re: 1jz-gte Octane requirements. Bugman Tue, 28 January 2003 03:28
Re: 1jz-gte Octane requirements. Tue, 28 January 2003 03:43
Re: 1jz-gte Octane requirements. Helmann Tue, 28 January 2003 05:36
Re: 1jz-gte Octane requirements. Nark Tue, 28 January 2003 05:43
Read Message Re: 1jz-gte Octane requirements. Ollygt Tue, 28 January 2003 06:15
Re: 1jz-gte Octane requirements. Nark Tue, 28 January 2003 06:24
Re: 1jz-gte Octane requirements. Norbie Tue, 28 January 2003 06:23
Re: 1jz-gte Octane requirements. Ollygt Tue, 28 January 2003 06:30
Read Message Re: 1jz-gte Octane requirements. SUPRAGTE Tue, 28 January 2003 10:28

Previous Topic: Bonnet Scope (for cold air intake)
Next Topic: Compression readings in an 18R-C

-=] Back to Top [=-

Current Time: Tue Mar 11 18:06:37 UTC 2025

Total time taken to generate the page: 0.0059230327606201 seconds

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.