Toymods Car Club Inc: General Car Talk => norgen valve, wastegate controller

Toymods Car Club
www.toymods.org.au

Toymods » General Car Talk » norgen valve, wastegate controller Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Ribfeast
Forums Junkie

Location:
Newcastle, Australia
Registered:
March 2005

Re: norgen valve, wastegate controller	Fri, 05 August 2005 05:44

OK I took one for the team and plonked down the cash for the article, here is the bits we need, any pricing you can get me would be appreciated ------------------ The Parts The parts were sourced from the German company IMI Norgren Pty Ltd - branches in most states and countries. The parts that were used were: * 1 x R07-200-RNKG Inline 07 1?4 Regulator Relieving 7Bar; * 1 x V07-200-NNKG Inline 07 1?4 Relief Valve 7 Bar; * 2 x 2069-02 07 Spring 0.7 Bar (brown); plus mounting brackets and four 1?4-inch barbed hose fittings to suit the regulator and relief valve. The total cost was A$83 (including GST). Note that the pressure reg and relief valve are nominally 7 Bar (ie are designed to set pressures up to ~100 psi), and so you need to buy the softer springs (rated at 0.7 Bar - 10 psi) to go inside each of them. The bodies easily unscrew and spring replacement takes only a few moments. If you are going to be running very high boost, retain the higher rated springs as well - for 1 Bar (14.5 psi) boost, the softer springs worked fine, despite their nominal 10 psi setting. In addition, you will need a metre or so of 1?4 -inch fuel hose (or similar high temp hose) and 6 hose clamps. In fact I used 5/16th ID hose - the 1?4 inch fittings seemed a little large for 1?4 inch hose. [Report message to a moderator]

Current Time: Mon Jul 21 01:30:35 UTC 2025

Total time taken to generate the page: 0.0085189342498779 seconds

.:: Contact :: Home ::.