Toymods Car Club Inc: Tech & Conversions => J160 speedo cable

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » J160 speedo cable Show: Today's Posts :: Show Polls Email to friend

Author

Topic

cultus
Occasional Poster

Location:
Kuala Lumpur, Malaysia
Registered:
April 2005

Re: J160 speedo cable	Fri, 02 September 2005 13:11

Thanks Norbie, you are right : the 2 housings are the same. However, the J160 has 35 teeth, a bit more than the W57. What I did was swap the gears, the diameters of the two shaft are the same but the J160s was shorter by about 1.5cm. So I cut the W57 shaft (correct length of course), machined the tip to fit the J160s, MIG then machined the weld. Thanks again. [Report message to a moderator]

Subject Poster Date

Read Message J160 speedo cable cultus Sun, 28 August 2005 11:14
Re: J160 speedo cable Norbie Sun, 28 August 2005 13:06
Re: J160 speedo cable cultus Mon, 29 August 2005 13:49
Re: J160 speedo cable Norbie Mon, 29 August 2005 22:52
Re: J160 speedo cable cultus Fri, 02 September 2005 13:11
Read Message Re: J160 speedo cable justcallmefrank Sat, 03 September 2005 00:02

Previous Topic: 3sgte blow off vavle removal?
Next Topic: lights

Current Time: Sun Aug 3 09:41:39 UTC 2025

Total time taken to generate the page: 0.0040738582611084 seconds

.:: Contact :: Home ::.