thoughts:
- wiring
I'm pretty sure that I did the wiring correctly. I have one doubt however. The heat sink, distrubitor noise filter. A B-O wire (power) comes out of it along with a W-B wire (usually ground) it goes to the 4agze fuse box. but I cant find it on any wiring diagram so I took a guess and grounded the W-B wire.
- timing
I figure even if timing was off shouldnt it at least spark?
- ignition leads
I'm getting power
- coils
Coils are getting power and there is a slight change in voltage in the signal wire. I measured it to be about .2 volts. Normal?
- ingitior
I am getting power to the igniter and it is sending pulsers.. .2 volts though.
Tue, 06 September 2005 19:01
