Toymods Car Club Inc: Tech & Conversions => 4agze wiring help!!!! PLEASE

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 4agze wiring help!!!! PLEASE Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Grant
Forums Junkie

Location:
Newcastle, NSW, Australia
Registered:
May 2002

Re: 4agze wiring help!!!! PLEASE	Sun, 09 February 2003 21:14

ELS2-------Idle-up diode NOT REQUIRED ELS1-------Battery JB3 NOT REQUIRED FPR--------Fuel Pressure relay DON'T NEED IT TO RUN THE ENGINE BUT MAY REDUCE LIFE OF PUMP IF NOT USED. GOES TO THE RELAY THAT CONTROLS THE VOLTAGE TO THE PUMP VIA A RESISTOR BANK. IT DOES NOT GO TO CIRCUIT OPENING RELAY. CIRCUIT OPENING RELAY GOES TO PIN FC STA--------Ignition starter STARTER SIGNAL TO ECU. COMES FROM THE STARTER WIRE. WITHOUT THIS SIGNAL THE ENGINE WILL NOT RUN. CCO--------Diagnositic connector NOT REQUIRED. Hope this helps. [Updated on: Sun, 09 February 2003 21:17] [Report message to a moderator]

Current Time: Sat Jul 26 09:51:10 UTC 2025

Total time taken to generate the page: 0.003734827041626 seconds

.:: Contact :: Home ::.