| Author | Topic |
|---|
I Supported Toymods
Location:
south Melbourne/KL
Registered:
June 2004
|
|
Re: 20v valve stem seals
|
Sun, 18 September 2005 17:42
 
|
 |
| Flogbag wrote on Sun, 18 September 2005 20:24 |
ive done it and yes it is a bitch...
you have to remove the cams and buckets then i used two screwdrivers (big ones) and pushed down either side on top of the spring cap to get the colets out pain in the ass but the spring compressor tool doesnt fit in there unless u got one of the ones where u need the head off
make sure u put the cyliner ur doin on tdc and use a tool to put where the spark plug goes hooked up to a compressor to keep the valve up
|
assuming i have piston at TDC and the valve falls in, would it fall in all the way?? 
|
|
|
| | Subject | Poster | Date |
|---|
 |
20v valve stem seals
|
b1gb3n | Sun, 18 September 2005 06:06 |
|
Re: 20v valve stem seals
|
Flogbag | Sun, 18 September 2005 10:24 |
|
Re: 20v valve stem seals
|
dingaling | Sun, 18 September 2005 11:34 |
|
Re: 20v valve stem seals
|
b1gb3n | Sun, 18 September 2005 17:42 |
|
Re: 20v valve stem seals
|
bluehachi | Sun, 18 September 2005 12:53 |
|
Re: 20v valve stem seals
|
adamaw11 | Mon, 19 September 2005 04:36 |
|
Re: 20v valve stem seals
|
b1gb3n | Tue, 20 September 2005 06:23 |
|
Re: 20v valve stem seals
|
Sam_Q | Wed, 05 October 2005 23:22 |
|
Re: 20v valve stem seals
|
dingaling | Thu, 06 October 2005 00:47 |
|
Re: 20v valve stem seals
|
ChuckLandwehr | Thu, 06 October 2005 04:53 |
