Toymods Car Club Inc: Tech & Conversions => Intercooler piping question?

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Intercooler piping question? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Japstang
Regular

Location:
Toowoomba
Registered:
September 2004

Intercooler piping question?	Fri, 30 September 2005 13:50

I have a 1G-GTE setup in my RT-142. With a small front mounted intercooler, the piping is 2.5' just from guessing. I am getting a bigger IC but am not sure whether to get 2.5' or 3' inlet/outlet on the IC. They both cost the same but I am thinking that the piping to set it up would be cheaper if I used 2.5' I am not chasing huge horsepower figures but what limitations powerwise will a 2.5' setup have over a 3' one, if there is any? Thanks [Report message to a moderator]

Current Time: Fri Jan 10 18:00:00 UTC 2025

Total time taken to generate the page: 0.0098850727081299 seconds

.:: Contact :: Home ::.