Toymods Car Club Inc: Tech & Conversions => 1j idle

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 1j idle Show: Today's Posts :: Show Polls Email to friend

Author

Topic

CrUZsida
Forums Junkie

I supported Toymods

Location:
Australia
Registered:
November 2003

Re: 1j idle	Mon, 03 October 2005 14:36

Ignore the thickness gauge bit. Just make sure IDL is SC at closed throttle (plate fully closed) and OC a teeny bit open [Report message to a moderator]

Subject Poster Date

Read Message 1j idle ripfast Fri, 30 September 2005 09:41
Re: 1j idle CrUZsida Fri, 30 September 2005 09:45
Re: 1j idle ripfast Fri, 30 September 2005 10:39
Re: 1j idle ripfast Fri, 30 September 2005 11:25
Re: 1j idle CrUZsida Fri, 30 September 2005 11:25
Read Message Re: 1j idle CrUZsida Fri, 30 September 2005 11:29
Re: 1j idle ripfast Fri, 30 September 2005 11:31
Re: 1j idle ripfast Fri, 30 September 2005 12:24
Re: 1j idle CrUZsida Fri, 30 September 2005 14:16
Re: 1j idle ripfast Sat, 01 October 2005 00:35
Read Message Re: 1j idle ripfast Sun, 02 October 2005 06:23
Re: 1j idle CrUZsida Mon, 03 October 2005 05:14
Re: 1j idle CrUZsida Mon, 03 October 2005 05:14
Re: 1j idle ripfast Mon, 03 October 2005 10:40
Re: 1j idle BabyZ Mon, 03 October 2005 12:22
Re: 1j idle CrUZsida Mon, 03 October 2005 14:36
Read Message Re: 1j idle ripfast Mon, 03 October 2005 23:43

Previous Topic: 1JZ/2JZ/7M/1UZ head stud dimensions?
Next Topic: 1G-GTE into RA40. my conversion - **VIDEO** it runs

Current Time: Thu Jul 31 05:05:36 UTC 2025

Total time taken to generate the page: 0.0041089057922363 seconds

.:: Contact :: Home ::.