Toymods Car Club Inc: Tech & Conversions => URGENT, help with circuit open relay output voltage...

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » URGENT, help with circuit open relay output voltage... Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Phrostbyte
Forums Junkie

I supported Toymods

Location:
Frankston, Victoria
Registered:
April 2004

URGENT, help with circuit open relay output voltage...	Sun, 09 October 2005 06:14

Hey peeps, Firstly I want to say thanks to all the peeps from these forums that helped me out, couldn't have done the conversion without yas. I'm up to the absolute final stage of my conversion, just about to mount the fuel pump. After screwing up the wiring of my circuit open relay about 4 times, I finally looked deep at the wiring diagram and the plug pinout diagram and did it properly. With my multimeter in hand i turned the starter to check the output voltage... EXACTLY ONE VOLT?? Made me go "wtf?". Is this normal? Like is it meant to be only 1 volt while starting, then once the starter goes off and the engine raises above 5RPM and the ECU kicks it into action off the 12V EFI, it raises to 12V? It's the last thing I need to figure out till i fill the tank and start the car, so I really want a fast reply on this. Thanks heaps! Kev. [Report message to a moderator]

Current Time: Mon Jul 21 15:11:33 UTC 2025

Total time taken to generate the page: 0.0039858818054199 seconds

.:: Contact :: Home ::.