| Author | Topic |
|---|
I supported Toymods
Location:
Australia
Registered:
November 2003
|
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
Tue, 11 October 2005 05:48
 
|
 |
| dingaling wrote on Tue, 11 October 2005 11:43 |
jza70 engine crossmember - Yes, not sure on mounts.
jza70 gearbox crossmember - Probably, but measure it, its a 5 sec exercise
jza70 1jz-gte sump - Should be the same as JZZ30
jza70 manual pedal set - You may luck out here, they may be the same, if not, they can fetch a few $$
Jza70 Power steering Pipes - NFI
Jza70 Aircon pipes/air compressor? - Compressor should be the same, worst case lines will be custom ($50)
Jza70 Intercooler and piping? - Would you use the stock stuff anyway?
Jza70 Air intake piping? - As above
Jza70 Wiring Loom? (would make it a plug and play affair then)- JZZ30 wiring is easy anyway, and not 100% sure on JZA70 being plug and play, I don't think it is
Jza70 Gearbox Shifter (jzz30 ones are shorter)? - Some JZZ30 ones have the same box as JZA70, some have different rear housing. Not sure on shifter length
|
[Updated on: Tue, 11 October 2005 05:49]
|
|
|
| | Subject | Poster | Date |
|---|
 |
jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 02:23 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
ndgcpr | Tue, 11 October 2005 02:35 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 02:42 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
Yian | Tue, 11 October 2005 02:50 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
Lambolica | Tue, 11 October 2005 02:56 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 03:43 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
CrUZsida | Tue, 11 October 2005 05:48 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
lumpy | Tue, 11 October 2005 07:08 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
CrUZsida | Tue, 11 October 2005 07:35 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 07:48 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
negative boost | Tue, 11 October 2005 06:46 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
CrUZsida | Tue, 11 October 2005 08:04 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 10:21 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
CrUZsida | Tue, 11 October 2005 10:52 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 11:30 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
sideshow | Tue, 11 October 2005 12:32 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 12:45 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
sideshow | Tue, 11 October 2005 13:00 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Tue, 11 October 2005 23:53 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
negative boost | Wed, 12 October 2005 00:45 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Wed, 12 October 2005 02:20 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
negative boost | Wed, 12 October 2005 02:28 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
dingaling | Wed, 12 October 2005 02:33 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
lumpy | Wed, 12 October 2005 06:49 |
|
Re: jzz30 halfcut to convert MA70 to JZA70 (feggin peed off)
|
Lambolica | Wed, 12 October 2005 08:04 |
