| Author | Topic |
|---|
Location:
Melbourne
Registered:
November 2003
|
|
Re: Changing T50 Shifter Positions
|
Tue, 25 October 2005 00:38
 
|
 |
This is a little late but still useful I hope.
I've just swapped a TA22 T50 extension housing onto an AE86 T50. The complications are that the '86 box runs a remote shift and so the selector rods are of different lengths. The actuator ends of the 86 rods are inverted (the slots are towards the bottom of the box). However, the differences in the rods are all external to the main case. All of the indents and dowel locations are the same. When I swapped the shafts I retained the selector forks that were in the box.
I should put a caveat on this post in that the box has not been run in a car yet (and won't be for some time to come) and so there might be some minor issue that causes the whole lot to turn inside out. It doesn't appear that way yet as it all went together very smoothly. I'll report any disasters though.
Cheers,
Dan
|
|
|
| | Subject | Poster | Date |
|---|
 |
Changing T50 Shifter Positions
|
Bazooka | Tue, 06 April 2004 12:38 |
|
Re: Changing T50 Shifter Positions
|
oldcorollas | Tue, 06 April 2004 13:17 |
|
Re: Changing T50 Shifter Positions
|
BigWorm | Tue, 06 April 2004 13:41 |
|
Re: Changing T50 Shifter Positions
|
Bazooka | Tue, 06 April 2004 22:05 |
|
Re: Changing T50 Shifter Positions
|
ra23celica | Tue, 06 April 2004 23:31 |
|
Re: Changing T50 Shifter Positions
|
Bazooka | Wed, 07 April 2004 01:09 |
|
Re: Changing T50 Shifter Positions
|
dcleyne | Tue, 25 October 2005 00:38 |
|
Re: Changing T50 Shifter Positions
|
Bazooka | Wed, 26 October 2005 21:13 |
|
Re: Changing T50 Shifter Positions
|
September_Squall | Thu, 27 October 2005 02:35 |
|
Re: Changing T50 Shifter Positions
|
demuire | Thu, 27 October 2005 01:36 |
|
Re: Changing T50 Shifter Positions
|
Bazooka | Thu, 27 October 2005 03:16 |
