| Author | Topic |
|---|
Location:
Sydney Australia
Registered:
March 2005
|
|
7M-GTE Knock sensor fault
|
Thu, 27 October 2005 15:02
|
 |
Hi,
did the conversion preserving all the original 7mgte wiring and ecu and i keep getting a knock sensor fault if i rev the car to 4000prm or if i drive the car and it reaches bout 2500rpm, the loom was never cut between the ecu and sensors, continuity shows these cables are good, and i have replaced both knock sensors.
the engine seems a little hesitant when i accelerate too as if its holding back, boost is fine, and i run 98 octane fuel on it.
|
|
|
