Toymods Car Club Inc: Tech & Conversions => Sc12 Supercharger to 4age bluetop

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Sc12 Supercharger to 4age bluetop Show: Today's Posts :: Show Polls Email to friend

Author

Topic

TRD_07
Regular

Location:
Melbourne
Registered:
September 2005

Re: Sc12 Supercharger to 4age bluetop

Sat, 29 October 2005 01:31

4agetwincam wrote on Fri, 28 October 2005 21:59

sweet might try and pick up some ze pistons too lol.

how will i be able to adjust the fuel ratio, because i know i could play with the reistance or the o2 sensor but may only work until i put my foot down then take pre-programed path for fuel mixtures and wot ever else it does.

also on a slightly different topic would a turbo work with a supercharger? what would the result be?

you could trick the o2 sensor but best is to use an aftermarket piggyback like Apexi SAFC or Greddy E-manage. But i found out that if you can have full control over engine management i.e. manifold pressure, load etc, it's the most efficient. Either have a standard motor, or if the motor is modified, have aftermarket ecu as well.

You could get GZE pistons, but when taking out standard pistons you might have to bore the block a bit so the walls are smooth, which might mean u need one size bigger pistons. Even in a straight swap, i'm sure a GZE block is stronger than a standard GE , but i'm not too sure. Might be alright if you're not running insane amounts of boost.

turbo can work with SC, and most setups i've seen, as long as the SC and turbo don't boost at the same time i.e. SC turns off at certain revs or load the engine will run. Very difficult to configure i think.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sat May 10 02:11:28 UTC 2025

Total time taken to generate the page: 0.0048952102661133 seconds

.:: Contact :: Home ::.