| Author | Topic |
|---|
Location:
Terrigal
Registered:
May 2002
|
|
Re: People wanting easy seat conversion in RA2x
|
Thu, 20 February 2003 03:25
 
|
 |
Basically just got a long length of stainless angle.
One side of it was 50mm, other was about 30mm. Around 3 - 4mm thick.
Take the rails of the silva seats, then place a piece of the angle along each side of the seat that spans almost the entire length. There are a few bolt holes on the silva seats along the side, so just drill some holes through the angle and then it'll bolt up to the side of the seat..
Now take the original RA rails, and position them under the angle, you can use the original holes in the RA rails. Just drill holes in the angle to line up with these. You can decide how far back/forward you want the seat to be at this point also.
It all is very simple. If thats not clear i can try drawing some pictures.. Hard to explain! But took about 1 hour a seat at the most.
I paid $120 for the seats second hand. Or there abouts.
Cheers
Joel
|
|
|
