Author | Topic |
Location: Sydney
Registered: September 2004
|
Re: SETup for 4AGZE / W55 Gbox into AE86 ??
|
Mon, 07 November 2005 11:54
|
|
sprinter ae86gt wrote on Mon, 07 November 2005 22:22 | Hi
I was wondering if anybody knows the exact combination for fitting a W55 supra G/box up to a 4AGZE and then into a AE86 with the standard JDM tailshaft.
What G/Box bell housing recommended?
What G/box aft mount required / recommended ?
|
Dellow,niteparts and Bill Sherwood has them from time to time. The brand you get will determine which clutch fork/release bearing you use
Need a custom box mount.
Quote: | What clutch would be recommended for this running a 100KW flywheel ?
|
Depends on the power. Generally a 3-5 puck brass button with high clamp pressure plate (ie 1600lbs+) You'll need a 212 disk with 22 x 28.5mm centre.
Quote: | Can the JDM tailshaft be used without any mods, if mods what mods?
|
No. You might be able to re-use the back half but you need the yoke off the w55 to make a new tailshaft. Make sure you get it balanced properly.
Quote: | Would the engine need to be moved forward slightly for g/box bellhousing clearance or would the standard mounting position be fine.
|
Standard should be fine.
Quote: | Also what radiator ( ie 3 core etc) is an easy fitup so as to allow for the intercooler piping to pass between the radiator support pannel and radiator without and cutting of the pannels?
|
Measure it and then have a field day at the wreckers.
Eddie.
ps you could've found all this by searching but im bored atm
|
|
|