| Author | Topic |
|---|
Registered:
May 2002
|
|
Re: 3T-GTEU please read! @@
|
Fri, 21 February 2003 14:28
 
|
 |
ok i'll try and answer some of your questions...
-the breather pipe is your rocker cover ventilation pipe, this is usually connected to the inlet pipe(seen just below the pipe in the pic) or any inlet piping before the airflow meter. you possibly could connect in to the plenuum without too much harm (just that the computer won't know theres a bit extra air going in). Warning: This definately should not be blocked-up!! its not entirely legal but is ok for the engine to have it venting to the atmosphere, use a filter on it to stop oil leaking out.
-yep thats the throttle positioning sensor, you aren't suppose to play with it! you can take the cover off it to see when the contacts move to set the idle.
-thats where i want a BOV installed on my engine  .
-thats the idle adjustment screw, screw this to adjust the idle. hehe.
-the screw with the spring doesn't do much, not entirely sure what it was for, i usually see the two vacuum connections looped.
|
|
|
