F.A.Q.    Register    Login    Home Members    Search

Toymods » Tech & Conversions » cam grind and bucket/shim assembly ... Show: Today's Posts  :: Show Polls  Email to friend

Author	Topic
TA22-3SGTE Regular Location: MACKAY Registered: May 2002	Re: cam grind and bucket/shim assembly ... Sun, 23 February 2003 12:42 ed A couple of things to check out , (1) If you tip the valves by 1 mm make sure the valve tips still protrude above the valve retainers or the extra shim will hit on the retainers , sometimes after tipping valves the tip ends up lower than the retainer , This is normally not a problem as the underside of the bucket has that protrusion you mentioned as so the bucket and retainer still has clearance . (2) Is there enough heel on the cams to remove 2 mm , If so would the base circle of the cam lobe still be larger than the cam bearing journal as the edge of the buckets on some heads actually sit slightly under the edge of cam bearing journal , If the cam lobe base circle is smaller the buckets will hit on the cam bearing journals . Otherwise I can't see any problems with this setup . Trevor [Report message to a moderator]

	Subject	Poster	Date
	cam grind and bucket/shim assembly ...	ed_ma61	Sun, 23 February 2003 09:45
	Ed's ghetto spec high lift cams	gianttomato	Sun, 23 February 2003 10:16
	Re: Ed's ghetto spec high lift cams	ed_ma61	Sun, 23 February 2003 11:10
	Re: Ed's ghetto spec high lift cams	gianttomato	Sun, 23 February 2003 12:05
	Re: cam grind and bucket/shim assembly ...	ed_ma61	Sun, 23 February 2003 10:35
	Re: cam grind and bucket/shim assembly ...	gianttomato	Sun, 23 February 2003 10:39
	Re: cam grind and bucket/shim assembly ...	TA22-3SGTE	Sun, 23 February 2003 12:42
	Re: cam grind and bucket/shim assembly ...	ed_ma61	Sun, 23 February 2003 12:50
	Re: cam grind and bucket/shim assembly ...	ed_ma61	Sun, 23 February 2003 12:43
	Re: cam grind and bucket/shim assembly ...	gianttomato	Sun, 23 February 2003 14:01

Previous Topic:	Removing AE86 rear bumper?
Next Topic:	7m / 4age shim sizes??

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.