Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » working with plastics...

Show: Today's Posts  :: Show Polls 
Email to friend  		Return to the default flat view Create a new topic Submit Reply
AuthorTopic
clubagreenie
Forums Junkie


Location:
1st street on the right
Registered:
November 2002
 
Re: working with plastics... Mon, 14 November 2005 07:10 Go to previous message
You can get these push in brass threded inserts for plastic/timber that are knurled on the outside for grip. Mullings fatener have them but I don't remember what they are called.

Get some trim of the same origin, melt with a small butane burner and use a soldering iron to finish. Then you can redrill if necessary.
  Send a private message to this user    
[Message index]

SubjectPosterDate
Read Message   working with plastics... fuzz!Sun, 13 November 2005 14:20
Read Message   Re: working with plastics... fuzz!Mon, 14 November 2005 06:49
Read Message   Re: working with plastics...  clubagreenieMon, 14 November 2005 07:10
Previous Topic:7M-GTE Knock sensor fault
Next Topic:w5x + 4age clutch questions

Goto Forum:
-=] Back to Top [=-

Current Time: Sat Nov 30 06:19:54 UTC 2024

Total time taken to generate the page: 0.0070831775665283 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.