Author | Topic |
Location: Pine Rivers QLD
Registered: April 2005
|
1G-GTE info
|
Sat, 26 November 2005 03:11
|
|
OK 1G-GTE's i need some help asap. I got put my car in for a service and a quick dyno run and to fit 2 gauge senders as i was being lazy, and they wouldn't give me the car till i forked out $450!!! thats fucked, anyway, i need to know where the water temp sender is on the 1G, for the long story read on.
__________________________________________________ __________
I asked them to fit a water temp sender and a oil pressure sender. I specifically asked for the water temp sender back so i could turn my dash gauge into something else, but when i got the car it only had the oil pressure sender on the seat, i asked what was the go and they said they had to T piece the water temp to to stop it stalling (i think they removed the ECU water temp).
Anyway i said fair enough and drove home. and to my dismay the dash temp didn't work. so i got into it this morning and found that they drilled a new hole in the front of the housing to fit the new sender. i also found the old sender wire floating around the engine bay, it is not long enough to reach the new sender so they mustn't of swapped the new for old. i can find a green ECU sender and a brown ECU sender but not the single wire plug to plug this wire in, any help would be appreciated.
__________________________________________________ ___________
On another note my oil pressure gauge fluctuates ALOT. When the motor is not idling it sits between about 80 - 100 PSI. Is this right??? As i thought it sounded a bit high, at idle it is down around 30 PSI.
Thanks for your help
|
|
|
| Subject | Poster | Date |
|
1G-GTE info
|
ndgcpr | Sat, 26 November 2005 03:11 |
|
Re: 1G-GTE info
|
Dust | Sat, 26 November 2005 16:07 |
|
Re: 1G-GTE info
|
hokey | Sun, 27 November 2005 00:43 |
|
Re: 1G-GTE info
|
justcallmefrank | Sun, 27 November 2005 00:43 |
|
Re: 1G-GTE info
|
ndgcpr | Sun, 27 November 2005 12:50 |
|
Re: 1G-GTE info
|
justcallmefrank | Mon, 28 November 2005 03:07 |