| Author | Topic |
|---|
Location:
Sydney
Registered:
October 2003
|
|
Re: MR2 Gen3 conversion, error code 14
|
Sun, 04 December 2005 19:49
 
|
 |
The way you wired it up, if you used all the electronics from the gen3, you should be OK. You did use the coil/ignitor/ECU off of the gen3?
As you can in the image below, the 'A' connector (the one on the right), which is your body loom, hasn't changed at all. So as long as you have the gen3 computer, the two plugs from the engine loom should be right at home.
edit: I meant right, but typed left
[Updated on: Sun, 04 December 2005 22:26]
|
|
|
| | Subject | Poster | Date |
|---|
 |
MR2 Gen3 conversion, error code 14
|
DamMR2T | Sat, 03 December 2005 11:58 |
|
Re: MR2 Gen3 conversion, error code 14
|
sideshow | Sat, 03 December 2005 23:18 |
|
Re: MR2 Gen3 conversion, error code 14
|
DamMR2T | Sat, 03 December 2005 23:57 |
|
Re: MR2 Gen3 conversion, error code 14
|
sideshow | Sun, 04 December 2005 00:55 |
|
Re: MR2 Gen3 conversion, error code 14
|
DamMR2T | Sun, 04 December 2005 04:51 |
|
Re: MR2 Gen3 conversion, error code 14
|
davedave | Sun, 04 December 2005 19:49 |
|
Re: MR2 Gen3 conversion, error code 14
|
DamMR2T | Tue, 06 December 2005 10:42 |
|
Re: MR2 Gen3 conversion, error code 14
|
camryGT? | Sun, 11 December 2005 02:47 |
