Toymods Car Club Inc: Tech & Conversions => 7MGTE oil cooler hose size?

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » 7MGTE oil cooler hose size? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

ed_ma61
Forums Junkie

Location:
Lost in the K hole
Registered:
May 2002

Re: 7MGTE oil cooler hose size?

Fri, 07 March 2003 05:38

SUPRAGTE wrote on Fri, 07 March 2003 16:26

Yes i'm just using the standard fitting that fits between the block and the oil filter.

ahhh no no no,

sorry, i didnt mean that alloy piece between the oil filter and block. there is another way of mounting oil coolers to the 7m block: 'down' ie 'lower' on the block beneath the oil filter, theres a diamond shaped blanking plate on the block - thats where the 7mge oil coolers run out from. The fitting that goes to THIS outlet is presure regulated.

i have no idea if the 7mgte sandwich plate type oil filter fitting has a pressure regulator in it (never really looked), but i suspect it would - a) because the oil cooler used isnt a pressurised type, and b) it still sources oil from 'before' the filter, at a high pressure part of the system, and runs it back to the sump. if you had no regulator with this setup, the engine would never see oil at low rpm.

so, in summary, i dunno.. but id be suspecting that there is a bypass regulator in there

cheers
ed

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Mon Dec 23 03:56:37 UTC 2024

Total time taken to generate the page: 0.0081920623779297 seconds

.:: Contact :: Home ::.