| Author | Topic |
|---|
I supported Toymods
Banned User
Location:
Brisbane
Registered:
May 2002
|
|
Re: easiest way to wire up a loom
|
Tue, 18 March 2003 06:55
 
|
 |
If its anything like the GT4 every thing will be wired through 1 big loom which goes out through the passenger side all the way around the front and back in the drivers side!
But what I did was cut the loom where it enters the drivers side and then pull all the tape off the loom! After this I found the plug that goes to the light switches and then traced where all those wires go and then chopped them out! I did this for everything until I have only the wires that go to the ecu from the engine! I didnt even have a fuse box connected!
After I had all that shit removed and out of the way, I pulled the rest of the loom out and neatly spread it on a large table.
Now using a wireing diagram I traced every wire from the ecu makeing sure that the wire went to where it should be! For the fuses I just used a cheap fuse holder instead anything that came with the halfcut!
I would hope that you have some knowledge of electronics because this is not as easy as it might sound! Trust me, I do this for a living and it took me 3 days to sort mine out!
|
|
|
