| Author | Topic |
|---|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: ra60/ma61 struts - camber
|
Wed, 19 June 2002 08:54
 
|
 |
I put ra60 struts into my ae86 without any problems, just hafta swap the spring cups over too. Use the lower arms from an ra60, causes no camber problems as it is the same length. RA60 steering arms are fine too, with ae86 tie rod ends.
My little problem is with camber, but its too much positive, and on one side only, I my car must be bent slightly somewhere - even with KMAC strut tops, can't quite get neg camber on one side, but still I don't think you'll find thats got anything to do with the struts, as the lower arms are the same length. Good luck 
|
|
|
| | Subject | Poster | Date |
|---|
 |
ra60/ma61 struts - camber
|
chrisss | Tue, 18 June 2002 00:00 |
|
Re: ra60/ma61 struts - camber
|
justcallmefrank | Tue, 18 June 2002 00:42 |
|
Re: ra60/ma61 struts - camber
|
humble | Tue, 18 June 2002 01:19 |
|
Re: ra60/ma61 struts - camber
|
chrisss | Tue, 18 June 2002 06:27 |
|
Re: ra60/ma61 struts - camber
|
humble | Tue, 18 June 2002 09:40 |
|
Re: ra60/ma61 struts - camber
|
mrshin | Wed, 19 June 2002 08:54 |
|
Re: ra60/ma61 struts - camber
|
Norbie | Wed, 19 June 2002 09:35 |
|
Re: ra60/ma61 struts - camber
|
TE72_Turbo | Wed, 19 June 2002 12:25 |
|
Re: ra60/ma61 struts - camber
|
chrisss | Wed, 19 June 2002 12:29 |
|
Re: ra60/ma61 struts - camber
|
TE72_Turbo | Wed, 19 June 2002 13:00 |
|
Re: ra60/ma61 struts - camber
|
chrisss | Wed, 19 June 2002 13:19 |
|
Re: ra60/ma61 struts - camber
|
Jonny2TG | Thu, 20 June 2002 04:12 |
|
Re: ra60/ma61 struts - camber
|
purpleminiep | Fri, 28 June 2002 14:50 |
|
Re: ra60/ma61 struts - camber
|
daytona | Sun, 30 June 2002 20:05 |
