| Author | Topic |
|---|
Location:
Canberra
Registered:
May 2002
|
|
Microtech MTX12 (on a 3tgt)
|
Mon, 23 June 2003 02:54
|
 |
Hi, just wondering if anyone can give me any advice or tips on setting up a microtech MTX12 on a 3tgt. I know it uses most of the original sensors but what else is needed (like coils, etc.)? As this was initially used on a rotary (I bought it off e-bay) I also have no base maps so any info on fuel and ignition maps would be very much appreciated, very very much  Basically anything anyone can tell me about setting up these computers, particularly on this engine), would be extremely appreciated (as I can get around to setting it up that much sooner). Also if anyone has any wiring manuals that could be of any use that could possibly be scanned or photocopied and sent to me (with some financial remuneration if need be) that'd be great too. Thanks guys. Chris.
|
|
|
I supported Toymods
Location:
Epping, Sydney
Registered:
May 2002
|
|
Re: Microtech MTX12 (on a 3tgt)
|
Mon, 23 June 2003 07:34
|
|
best bet it probably to buy another loom off microtech.
they're typically set up differently for different engines, and the lengths probably wont be correct for you.
they can also load a base map onto it for you
|
|
|
Location:
Adelaide
Registered:
May 2002
|
|
Re: Microtech MTX12 (on a 3tgt)
|
Mon, 23 June 2003 10:52
|
|
I only have a wiring diagram for the MT-4, fuel only computer, so I am unsure of the ignition side of wiring...
Brendon
|
|
|
Location:
sydney
Registered:
March 2003
|
|
|
