| Author | Topic |
|---|
Location:
syd- green valley
Registered:
May 2003
|
|
GTi dash help...
|
Tue, 11 November 2003 12:44
|
 |
any help appreciated.
want to get my dash out to change the blubs inside,
got everything off ok but wasn't sure to yank the dash out, ie about any wires hooked on to it or about the speedo cable.
question if i get it off and unhook the speedo cable , how do i get it back in, there is no space for my clumsy hands anywhere. and does the cable have to go back in the same spot it came out or is it ok to just stick it back in, in any position.
thanks.
|
|
|
Location:
W.A.
Registered:
October 2002
|
|
Re: GTi dash help...
|
Tue, 11 November 2003 13:49
|
|
|
im not sure if this helps but try taking off the steering wheel and prob the console below the actual dash it should make it easier....again im not sure but im just guessing.
|
|
|
I supported Toymods
Location:
Sutho/Hills NSW
Registered:
September 2002
|
|
Re: GTi dash help...
|
Tue, 11 November 2003 23:27
|
|
you have to press a side lever in on the speedo and it pops out, it just goes straight back on a certain way when you connect it back up. As for geting it out and need some length you can unscrew it in the engine bay and pull it out then pull the dash through which will then pull the cable through the firewall.
It screws back on easy aswell when your done
|
|
|
Location:
syd- green valley
Registered:
May 2003
|
|
Re: GTi dash help...
|
Wed, 12 November 2003 00:46
|
|
GTstar- cant do that theres a chunk of metal under it, thanks any way.
EvilJack- thanks dude , i'll give it a go, see how i go,
|
|
|
