Author | Topic |
Location: Canberra
Registered: May 2002
|
Last TA22 bits
|
Thu, 13 May 2004 12:13
|
|
At long last i have almost all the pieces i need to make my car drivable again. All i need now is an ignition barrel, the metal plates behind the bumper, the two supports for the said plates on either side of the radiator and that's it.
so if anyone can help, it's:
Ignition barrel
Metal plates
Metal plate supports
Also need to know, what'd be the best way to remove paint from a panel? Paint thinner or sanding?
Sam
|
|
|
I supported Toymods
Location: Perth, Western Australia
Registered: December 2002
|
Re: Last TA22 bits
|
Fri, 14 May 2004 00:20
|
|
I have a set of bumper filler panels - the metal plates you refer to, will PM you.
Removing paint depends on your available tools, cheapest option is a coarse sanding disc, this will be the quickest too. If you don't have the power tools to do that, use stripper and a paint scrapper, followed by a Prepsol wash.
Clint
|
|
|
Location: Canberra
Registered: May 2002
|
Re: Last TA22 bits
|
Sat, 15 May 2004 07:18
|
|
still looking for the supports for the metal plates and an ignition barrel, any help appreciated
Sam
|
|
|
Location: Canberra
Registered: May 2002
|
Re: Last TA22 bits
|
Sun, 16 May 2004 19:34
|
|
c'mon, someone must know someone with a ta22 shell sitting around just waiting for me to get these support brackets from. The ignition barrel isn't so important but the support brackets are, they're the final piece to getting my daily driver Celica back on the road.
Sam
|
|
|