Author | Topic |
Location: Melbourne
Registered: March 2003
|
|
|
Location: melb
Registered: June 2003
|
|
|
I supported Toymods
Location: I renounced punctuation
Registered: May 2002
|
Re: 7m Flywheel, Pressure plate, Clutch
|
Sun, 01 August 2004 00:42
|
|
7M, non turbo.
Pressure and clutch plate also good for 2JZGE.
|
|
|
Location: Melbourne
Registered: May 2002
|
Re: 7m Flywheel, Pressure plate, Clutch
|
Sun, 01 August 2004 02:29
|
|
Yep that defnitly does look like a 7mge setup, measure the depth of your p plate, that should be about 50mm or therabouts. You could also mate this setup up to a 1g, however you would need to modify your thrust bearing carrier to be 10mm shorter beacuase the p plate is 10mm thicker. You will find that you can get a heavier p plate for this flywheel than what you can for a 1g flywheel.
|
|
|
Location: Melbourne
Registered: March 2003
|
Re: 7m Flywheel, Pressure plate, Clutch
|
Sun, 01 August 2004 03:50
|
|
Correct. Pressure plate is 49mm thick.
Thanks
Andrew
|
|
|
Registered: June 2004
|
Re: 7m Flywheel, Pressure plate, Clutch
|
Sun, 01 August 2004 09:01
|
|
is this setup much better than a 4m's setup? or should i just get an aftermarket kit? aiming for about 200hp
|
|
|
Location: Melbourne
Registered: March 2003
|
Re: 7m Flywheel, Pressure plate, Clutch
|
Sun, 01 August 2004 11:46
|
|
OK Guys its gone. SOLD.
|
|
|