was wondering if someone could help me by telling or showing me a pic of where i hav to connect the hose in the engine bay to get the boost reading on a boost gauge??
im a bit lost in there...not sure what's what...thanx
also a question about pod filters....is it possible to jus connect a pod filter directly via a pipe straight into the throttle body or do u need to hav some sort of adaptor?? jus a bit confused....seen a few examples n some hav the filter connected to an adaptor then to the pipe n some jus goes straight through...
yeh..i have mine bypassed (2 psi more boost ).. and i can't remember where it went when it was factory..but that sounds right..the pod filter that was on my stock throttle body..had a 10 mm spacer..only cos it's in RWD config and i needed to spin her around 180deg..i simply had a nice 2.5" pipe with a bent that flanges out to a 3" with my K&N on the end..
Thu, 09 September 2004 16:03
).. and i can't remember where it went when it was factory..but that sounds right..the pod filter that was on my stock throttle body..had a 10 mm spacer..only cos it's in RWD config and i needed to spin her around 180deg..i simply had a nice 2.5" pipe with a bent that flanges out to a 3" with my K&N on the end..