Author | Topic |
Location: Castle Hill, Sydney
Registered: February 2004
|
RCA's don't fit!
|
Sun, 06 February 2005 10:11
|
|
ive struck a problem with my RCA's
i put sigma arms in the t18 with sigma ball joint, and now because ive lengthened the control arm its made the angle from control arm to strut tower too acute to line up the RCA to the bottom of the strut tower, i could get the spring compressor on and push up the strut and that would get it on, but i can see doing this resulting into ripping out the ball joint, i have 50mm RCA's, i'de say the car is now sitting about that much lower than stock so i'de like to stick with these if there is any way possible.
any ideas folks?
or if theres no other option but to go to smaller RCA's, anybody want to swop my 50mm's for some 32's? to suit AE86
|
|
|
Location: Gold Coast
Registered: October 2002
|
Re: RCA's don't fit!
|
Sun, 06 February 2005 10:26
|
|
the sigma arms must be loooong. what about some other toyota ones such as ra40 or 60 perhaps?
|
|
|
Location: Castle Hill, Sydney
Registered: February 2004
|
Re: RCA's don't fit!
|
Sun, 06 February 2005 11:00
|
|
naah the arms are a good length, only about 3 degrees neg camber, i think it might be more that the sigma ball joint has less travel?
|
|
|
Location: Sydney
Registered: April 2004
|
Re: RCA's don't fit!
|
Sun, 06 February 2005 12:34
|
|
adjustable camber tops?
|
|
|
Location: Ipswich
Registered: May 2002
|
Re: RCA's don't fit!
|
Sun, 06 February 2005 22:50
|
|
Different brand ball joints have different amount of travel too. My right and left ball joints are different, and I had issues with one of mine...
|
|
|