Author | Topic |
Location: Melbourne
Registered: July 2002
|
1JZ HG Help??
|
Wed, 16 February 2005 08:21
|
|
Hi guys
i bought a VRS kit from toyota and the bloody HG that was in it is a single layer,.. has anyone used these??? it seems to me that it will never seal,..what did you do??? should i use it or get an aftermarket one??? and also what should i torque it to??? thanks guys.
|
|
|
Location: melb
Registered: June 2003
|
Re: 1JZ HG Help??
|
Wed, 16 February 2005 14:21
|
|
the part no 4 the vrs should be 04112-46030 from memory
and the head gasket shoud be about 3 or 4 layer mls
|
|
|
Location: Melbourne
Registered: July 2002
|
Re: 1JZ HG Help??
|
Thu, 17 February 2005 10:20
|
|
3 or 4 layers it should be but its not,.. and before they gave me the 1JZ kit they made a mistake and gave me a 2JZ kit and the HG was the same Single layer,
anyone know the torque spec???
|
|
|
I supported Toymods
Location: I renounced punctuation
Registered: May 2002
|
|
|
Location: Melbourne
Registered: July 2002
|
Re: 1JZ HG Help??
|
Thu, 17 February 2005 10:44
|
|
aaaaaa good man,... so after the 34nm the 90part is twice am i right???
thank you very much for that....
|
|
|
I supported Toymods
Location: I renounced punctuation
Registered: May 2002
|
Re: 1JZ HG Help??
|
Fri, 18 February 2005 06:44
|
|
Leon that's right.
Just check and make sure it's the same for a 1JZ.....
|
|
|
Location: Melbourne
Registered: July 2002
|
Re: 1JZ HG Help??
|
Fri, 18 February 2005 08:55
|
|
wil certainly do so, thank you....
|
|
|