Author | Topic |
Registered: February 2005
|
2T Turbo?
|
Fri, 01 April 2005 01:51
|
|
Hi
Im thinking about trying a 2T turbo, as far as i understan i can use a 3t turbo manifoild, but what kinda carb do i need to use? is it possible to use the standard 2t carb?
any other thing i need to do to make this mod possible?
thanks in advance
|
|
|
Location: VIC, Sth Frankston.
Registered: July 2003
|
Re: 2T Turbo?
|
Fri, 01 April 2005 02:08
|
|
just swap in a 3tgte, believe me when I say that will be the simplest option.
|
|
|
Location: Brisbane
Registered: May 2002
|
Re: 2T Turbo?
|
Fri, 01 April 2005 02:10
|
|
I strongly recommend NOT using a carb with a turbo.
Yes you could use the stock carb if you mounted it pre-turbo (ie draw-through) but it won't flow adequate CFM once the turbo spools up. It would probably be big enough for a blow-through setup but significant mods would be required to make it work with positive pressure.
It will be much easier and far more effective to get a 2T-GEU and turbocharge that, trust me.
|
|
|
Location: brisbane
Registered: October 2004
|
Re: 2T Turbo?
|
Sat, 02 April 2005 00:25
|
|
3tgte will be the easiest by far, why try and do it yourself
when toyota has already designed and mass produced them
iv also thought about it and you would need a 2tgeu block and its the same as the 3tgeu so its just a lot of hassle and a few mods to swap it all over, if you are after a good setup you will
run efi, all the parts you will need are going to be 90% a 3tgte
anyway...
|
|
|