Author | Topic |
Location: Sydney
Registered: September 2003
|
Compliance ST165 GT4
|
Wed, 11 May 2005 14:11
|
|
Hey guys !
Just wondering if anyone has imported one and complied it ? if anyone had just wanted to know how much it set you guys back and also who did the work.Any assistance is greatly appreciated
|
|
|
I Supported Toymods
Location: Sydney
Registered: December 2002
|
Re: Compliance ST165 GT4
|
Wed, 11 May 2005 23:17
|
|
Most ST165's in the country would have been complied under the 15yr rule.
Need to add:
Baby restraint anchor points
Side instrusion bars
Dash light dimmer
etc.
Probably cost you about $2-3k for the mods plus engineers cert.
|
|
|
Location: Canberra
Registered: September 2003
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 00:00
|
|
This depends on the state your in but you would usually need.
2 X Side intrusion bars
2 X Lap sash seat belts in rear
2 X Child restraint points in rear
Unleaded fuel sticker
Emissions Sticker
Tyre placard
VIN Number placard
Engineers Sign off
Allow $1500 for all this work.
|
|
|
Location: Canberra
Registered: April 2003
|
|
|
Location: Adelaide, Gawler
Registered: March 2005
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 00:16
|
|
i think there on the floor in the boot like in my ra60 hatch
|
|
|
Location: Canberra
Registered: September 2003
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 00:18
|
|
Yes they do need child restraints , the like of my GTi-R the restraints were fitted to the roof.
wiso wrote on Thu, 12 May 2005 10:12 | excusme guys this is one thing I have been wondering for a while, do cars with floating parcel shelves actually have child restraint points.
I work at a garage that does rta inspections when I questioned this on my boss, we had a look at a series of cars we had at the time, and none of the little hatches with floating shelves had child restraints, only the cars with fixed shelves did.
I know it may be a little off topic but it kinda has to do with this cause a 165 has a floating shelf
|
|
|
|
Location: Sydney
Registered: April 2004
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 00:34
|
|
some others to add are
aus fuel filler
weigh bridge certificate
|
|
|
Location: Canberra
Registered: September 2003
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 00:37
|
|
Aus fuel filler is not needed anymore well at least in Canberra due to Leaded fuel no longer available / phasing out
As for weighbridge you could also use the weight listed on the bill of loading for the shipping company.
driftymcgee wrote on Thu, 12 May 2005 10:34 | some others to add are
aus fuel filler
weigh bridge certificate
|
|
|
|
I Supported Toymods
Location: Sydney
Registered: December 2002
|
Re: Compliance ST165 GT4
|
Thu, 12 May 2005 01:18
|
|
I'm pretty sure the child restraints in the ST185 are supposed to mount to the two brackets which I'm pretty sure hold the fuel tank in.
They are right at the back of the boot floor.
Not that the rear bucket style seating would be too good for shoving baby capsules etc. onto.
|
|
|