Author | Topic |
Location: Brisbane
Registered: October 2004
|
Stubborn Inner tie rod ends
|
Mon, 06 June 2005 05:17
|
|
hey all... gotta change the inner tie rod ends on my ra28, but the sons of bitches won't move...
i've managed to get the outer tie rod ends done and loosened the idler arm, so i have one of two options... i can remove the pitman arm, or the right inner tie rod end... but it ain't budging... any suggestions? i've got all the nuts loose, just can't crack the tapers...
|
|
|
Location: Brisbane, QLD
Registered: February 2003
|
Re: Stubborn Inner tie rod ends
|
Mon, 06 June 2005 06:05
|
|
Try soaking it in WD40\inox something like that
Or you could try some shock treatment(smack it with a hammer a few times around the taper...firmly but not too HARD)
|
|
|
Location: Brisbane
Registered: October 2004
|
Re: Stubborn Inner tie rod ends
|
Mon, 06 June 2005 06:22
|
|
RP7 and ROST OFF was all i could get my hands on... and persuasion techinique did jack... still tight as...
|
|
|
Location: Brisbane
Registered: May 2002
|
|
|
Location: Brisbane
Registered: April 2004
|
Re: Stubborn Inner tie rod ends
|
Mon, 06 June 2005 06:33
|
|
A good trick and usually works get two hammers and hit both sides of the boss at the same time this does loosen the taper.
|
|
|
Location: Brisbane
Registered: October 2004
|
Re: Stubborn Inner tie rod ends
|
Mon, 06 June 2005 22:44
|
|
yeah... tried that too... gonna jack the car up higher today, see if i can belt it into submission... stubborn prick
|
|
|