Author | Topic |
Location: western queensland
Registered: September 2004
|
3s unknown crankshaft???
|
Wed, 08 June 2005 11:17
|
|
help, i have a crankshaft in my 3sgte that has a smaller rear seal size to normal and i can't find a rearmain seal to fit? what is this crankshaft??
|
|
|
Location: Sydney
Registered: June 2005
|
Re: 3s unknown crankshaft???
|
Wed, 08 June 2005 22:59
|
|
hahhaha., funny u should say that , when i went to reco my 3SGTE i found that the rear main i bought from repco was to small aswell.., i argued wit them untill the cows came home.....however i found a place close to my work that sells the correct seal, the guys there is a asian and has been in the business for like 40 yrs...drop me a pm , if u want me to get u this seal..
|
|
|
I Supported Toymods
Location: Sydney
Registered: December 2002
|
Re: 3s unknown crankshaft???
|
Thu, 09 June 2005 02:02
|
|
Rokusans RMS is too big... EVL-184's is too small... maybe you two should swap seals
The crankshafts are probably different between Gen1,2 and 3 or you could have a GTE head on a GE block.
|
|
|
Location: Vancouver
Registered: June 2004
|
Re: 3s unknown crankshaft???
|
Thu, 09 June 2005 19:26
|
|
the 5SFE crank fits into a 3SGE block to give a stroker. the 5SFE rod journals are bigger, and the 5SFE output takes a slightly larger main seal.
take the info with a grain of salt
|
|
|
Location: western queensland
Registered: September 2004
|
Re: 3s unknown crankshaft???
|
Fri, 10 June 2005 21:19
|
|
yes ge block, have found a landcruiser one to fit, 2f? inside dia. = 84.85mm kit supplied 88.89mm
|
|
|