| Author | Topic |
|---|
Location:
Brisbane
Registered:
March 2004
|
|
|
Registered:
February 2005
|
|
Re: 6 540CC SARD low Impedance injectors $450
|
Mon, 29 August 2005 12:38
 
|
 |
What engine are these for?
|
|
|
Location:
Brisbane
Registered:
March 2004
|
|
Re: 6 540CC SARD low Impedance injectors $450
|
Tue, 30 August 2005 00:56
|
|
1JZ or 2JZ.
Side feed, but low impendance. Peak and Hold injectors. 3ohm.
|
|
|
I supported Toymods
Location:
Adelaide
Registered:
July 2004
|
|
Re: 6 540CC SARD low Impedance injectors $450
|
Thu, 01 September 2005 02:11
|
|
|
how do you change the impedance, I was aware that stock impedance on a 1JZ is about 13 ohms...
|
|
|
Location:
Brisbane
Registered:
March 2004
|
|
Re: 6 540CC SARD low Impedance injectors $450
|
Thu, 01 September 2005 02:55
|
|
I have already bought myself 3 resistors, 5ohm 50Watt suckers. I will wire them up inline with the injectors 12+ lines. A 1JZ is a dual firer (2 cylinders at once, so only 3 resistors needed). Pretty much I just am going to make my own resistor pack....
In the resistor pack you get 6 x 10ohm. Which takes the 3ohm up to 13ohm or so.
If you have dual you just need a 5ohm, but you need a large wattage resistor and good heatsink.
So yeah I was advertising to sell these ages ago, and decided to keep them and put them in my car. If someone buys them, well that's great...if they don't it doesn't bother me.
I will sell them down the track with ready made resistor pack  will work on any 1J, or 2J.
The rumour is that peak and holds give better response even in this setup (with resistor pack) than high imp. injectors...but that could just be bullcrap.
|
|
|
