Toymods Car Club Inc: Tech & Conversions => newbie needs help with 6m-ge pin-outs

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » newbie needs help with 6m-ge pin-outs Show: Today's Posts :: Show Polls Email to friend

Author

Topic

pinkytamz
Occasional Poster

Location:
timaru NZ
Registered:
July 2005

Re: newbie needs help with 6m-ge pin-outs	Mon, 18 July 2005 09:03

rip the top off your ecm and check to see if the pin-outs are labeled ... might get lucky ...... how many plugs do you have that plug in to your ecm 2 or three [Report message to a moderator]

bexi
Regular

Location:
sydney
Registered:
May 2002

Re: newbie needs help with 6m-ge pin-outs	Mon, 18 July 2005 13:01

just 2....? [Report message to a moderator]

pinkytamz
Occasional Poster

Location:
timaru NZ
Registered:
July 2005

Re: newbie needs help with 6m-ge pin-outs	Tue, 19 July 2005 06:02

thats good whats your ......e-mail will send you the ecm pin-outs . but if you open the top of your ecm it will be labeled on the bord just by the pins [Report message to a moderator]

bexi
Regular

Location:
sydney
Registered:
May 2002

Re: newbie needs help with 6m-ge pin-outs	Tue, 19 July 2005 10:17

moto8oy@hotmail.com thanks bexi [Report message to a moderator]

CrUZsida
Forums Junkie

I supported Toymods

Location:
Australia
Registered:
November 2003

Re: newbie needs help with 6m-ge pin-outs	Tue, 19 July 2005 12:33

Its possible, but others have done it without problems. No, the 5ME ecu does not have an o2 input. [Report message to a moderator]

Pages (2): [ « < 1 2]

Previous Topic:	Hyperboost -how to hold boost up top
Next Topic:	5MGE help

Current Time: Tue May 7 08:04:31 UTC 2024

Total time taken to generate the page: 0.012353897094727 seconds

.:: Contact :: Home ::.